Check all fasteners for tightness and tighten as required (refer to maintenance checklist).

Check for hydraulic motor and fluid leaks and repair immediately.

When disconnecting and reconnecting hydraulic lines, make sure the o-ring seal is in its proper seat. These can become unseated during the re-assembly process resulting in hydraulic leaks.

Grease drive shaft bearings.

Check chains for tightness. Do not over-tighten.

Pallet Dispenser Only

• Check latch bushing wear -
  see Figure 1
• Check elevator cam followers -
  See Figure 2 

Pallet and Block Dispenser Only

• Check clamp wear pads
  

Check chain guides.

Figure 1

Figure 2