|
SERVICE
TIP
Extending
Mold Life
By observing the
following basic rules, it is possible to extend the life of a mold:
- It is very important
that all parts and mating surfaces are thoroughly cleaned before
assembly
- Be certain that
parts are properly aligned and use correct torque requirements. To be
sure that the parts are square, use a good working surface or a mold
jig (example: Besser # 383208)
- Visually inspect the
parts to ensure that they are not burred or scored
Note: Always start with
new lock washers and use only a brass hammer when assembling a mold.
Posted 13 August 2001
|
